How to make a mono synth track stereo?

The place for general discussion of Cakewalk Pro Audio.

How to make a mono synth track stereo?

Postby mikejf » Tue Dec 02, 2003 6:00 pm

When I play one of the sythn instruments that came with Cakewalk, it's mono. How do I make it stereo?

Mike
mikejf
 
Posts: 3
Joined: Tue Dec 02, 2003 5:55 pm

Re: How to make a mono synth track stereo?

by Sponsor

Forum Sponsor
 

Postby GretscGuy » Wed Dec 03, 2003 6:02 pm

If you have a mono sound source, you can't 'make it stereo'. However you can do some tricks to give you 'fake stereo'.

1- Take the mono signal, copy it and paste it into a new track.

2- Pan the two identical tracks hard left and hard right respectivley

3- Do one of the following:

- EQ one of them differentley
- Set a short delay (7ms?) on one side
- add an effect (like a chorus) on one of the sounds

You can also send a mono signal into a stereo effect like a reverb. Pan the reverb returns hard left and right.

Hope this helps.
Good Luck!
GretscGuy
 
Posts: 442
Joined: Sat Oct 18, 2003 1:26 pm
Location: Massachusetts USA



Similar topics


Return to General Cakewalk

Who is online

Users browsing this forum: No registered users and 1 guest

cron

Music Engravers and Music Copyists
   Finale - Sibelius - Cakewalk - Archives - Cakewalk Books - Contact


Copyright © 1994 - 2019 by C.M. Press, LLC