Page 1 of 1
How to make a mono synth track stereo?
Posted: Tue Dec 02, 2003 6:00 pm
by mikejf
When I play one of the sythn instruments that came with Cakewalk, it's mono. How do I make it stereo?
Mike
Posted: Wed Dec 03, 2003 6:02 pm
by GretscGuy
If you have a mono sound source, you can't 'make it stereo'. However you can do some tricks to give you 'fake stereo'.
1- Take the mono signal, copy it and paste it into a new track.
2- Pan the two identical tracks hard left and hard right respectivley
3- Do one of the following:
- EQ one of them differentley
- Set a short delay (7ms?) on one side
- add an effect (like a chorus) on one of the sounds
You can also send a mono signal into a stereo effect like a reverb. Pan the reverb returns hard left and right.
Hope this helps.
Good Luck!