Page 1 of 1

Need help with Korg T3 instrument definition

Posted: Sun Apr 24, 2005 1:11 pm
by madmix
Hi All,

I have been having trouble getting my Korg T3 synth to properly switch banks through Sonar (using an ins file). I have downloaded the one on the cakewalk site, as well as a couple of others but when I use Sonar to select any patches on my T3's B bank, all that happens is that the correponding patch # on the A bank will be selected. I have the T3 set to combi mode and I am setting the Sonar track MIDI channel to 2 or above (the T3 will respond to program change data on MIDI channel 1 by switching combis). I have tried bank select method 0 and 3. Here is the instrument definition file that I have tried so far. Any help would be appreciated:

Thanks!

Ken

file:

; ----------------------------------------------------------------------

.Patch Names


[Korg T3 Bank A]
0=A 00 Aeroglide
1=A 01 Piano 16'
2=A 02 Brass 1
3=A 03 Ooh/Ahh
; patchlist truncated by Ken for space.

[Korg T3 Bank B]
0=B 00 One World
1=B 01 Piano2 16'
2=B 02 Alto Sax
3=B 03 Spectrum 2
; patchlist truncated by Ken for space.

; ----------------------------------------------------------------------

.Note Names


[Korg T3 Drums]
35=Timpani
36=Pro BD
37=Kick 3
; truncated by ken for space.

; ----------------------------------------------------------------------

.Instrument Definitions


[Korg T3]
BankSelMethod=3
Patch[0]=Korg T3 Bank A
Patch[1]=Korg T3 Bank B
Patch
=Korg T3 Bank A
Key[0,9]=Korg T3 Drums
Key[1,9]=Korg T3 Drums
Drum[0,9]=1
Drum[1,9]=1

Posted: Mon May 02, 2005 5:59 am
by Dr Sax
CHeck you PM's. I have a suggestion there.

T# not responding properly to bank change messages

Posted: Mon May 02, 2005 12:26 pm
by madmix
I've tried everything. See this post:

http://www.cakewalk.com/forum/tm.asp?m=446239

If you can offer any suggestions, I'd be indebted. I think the T3 just can't do bank changes via MIDI (least not from combi or sequencer mode).

Ken

Need help with Korg T3 instrument definition

Posted: Mon Apr 10, 2017 7:26 am
by RomalaG.Mot
I want to write data into a file on my CASIO fx-9860g and then read the data from the file with a calculator program. I dont have my manual any more, so I need somebody to tell me how this is done. Thanks
Part 1: create the file
Part 2: the program syntax to read the data from the file
Any help appreciated.